Tailscale with zero clients connected takes 7% of CPU time: is this normal?
I tried to delete and recreate the container, but there's still this insane power consumption.
For comparison, cloudflared doing a tunnel to hundreds of users takes 0.06% of CPU time on the same server
On my machine it's consuming about 0.5% - 1.0% of cpu time, which is higher than zerotier in the same machine (almost zero).
Tailscale does a lot more things than just tunneling though. For example, on default installation it'll catch all outbound dns request on the machine and route them through MagicDNS (100.100.100.100).
That's weird. I closed the docker on that specific machine (ryzen 5), copied the docker-compose directory (=same config) on an i5-6500T and now it's using just 0.1% of CPU time.
Go back to ryzen and it's 8% again 🤷
I just checked my AMD box and tailscale there can consume ~15% of cpu time when the tunnel is under active use. When it's not used it's ~1.5%. But it's a low power old AMD cpu though (AMD G-T56N), so I'm not use if it compares to Ryzen 5. On my intel machine, it's ~5% when under active use, and idle at ~0.5%.
One thing you could try doing if you feel up to it is to build Tailscale from source code. Often when built for your specific machine, performance improves.
I use tailscale on my Ruzen system, and it always stays under 1% usage. Usually below 0.5%.
Isn't CPU % is per thread?
Why is your system load >5 with such little CPU usage? Seems like there is a lot of i/o on your system.
If it's network traffic going over your VPN that could explain it.
Because that's a docker container on a "busy" server (mostly WordPress wasting cycles generating pages for some bots that really have to visit my blog over and over and over and over)
(Top from inside the container)
time to do some perf profiling