Hey y'all. Im on the hunt for an app that'll automatically record the start and ends of my rides based on my location. Ive been wanting to kniw my time improvemwnts on my daily commute but rarely remember to start the time before riding.
This article seems either written or assisted by Ai. It flows really weirdly.
I've had my eyes on this one for a while. My daily driver is their Navigator frame. I've been planning on converting it to an Ebike using a 750watt motor kit.
This is basically my assessment too. Good write up :)
Thank you so much. As a Relay fan, I've been looking for something to fill that space. And lift off wasn't quite doing it for me.
I'm with you 100% if push comes to shove I'm selling everything else before selling my tools. Unfortunately. My tools are where a lot of my money is lol.
I'm with you 100% if push comes to shove I'm selling everything else before selling my tools. Unfortunately. My tools are where a lot of my money is lol.
I've always wanted to go the fairphone route but have been worried about the whole ecosyatem discontinuing and I'd be left without good replacements.
Direction specific force loading. In this particular instance, Having it run the infill along the perimeter of the part would improve it.
Yellow is perimeter lines, the goal is to not use infill at all, and to just use multiple perimeter passes.
They dramatically increase print times and increase blemishes. It's such a small surface area, that it just ends up creating blobs and shakes the printer.
Hey y'all. I am trying to do a max perimeter style print, and want to know how to remove these smaller sections. I know I could reduce wall count until I remove them, however that isnt dynamic, and leaves larger gaps than I want in other areas. Is there a setting in PrusaSlicer im missing? I messed around with a few but they didnt give me the results I was looking for.