qBittorrent network interface bind not working?
qBittorrent network interface bind not working?
I am using ProtonVPN, and have (or so I thought) set up qBittorrent to bind to the network interface that ProtonVPN is using (tun0). The connection symbol turns red if I turn off the VPN, and downloads will stop. However, when checking the torrent address on ipleak.net, it seems that this bind is not working properly - my real IP shows up after I have disconnected my VPN. I thought that there shouldn't be any connections made when traffic is not via the tun0 interface, so that my real IP should never be known by the detection tool. Am I wrong?
I have not configured the kill switch, but perhaps I should do so?
You're viewing a single thread.
After you disconnect the VPN the interface likely goes down so qbit falls back to the actual connection I think.
That is what the interface bind is supposed to prevent, or at least that is what I thought it was supposed to prevent. To avoid IP leaks in case of a lost VPN connection. I wonder if I've misunderstood it, or misconfigured it or something else.
You have some configuration wrong somewhere. It shouldnt connect to anything
You’re correct that it’s supposed to prevent leaks. It shouldn’t fall back, though there may be a checkbox for that somewhere in the menu that you have accidentally ticked? I’m not near my computer at the moment, so I can’t just go digging in my own menus to verify.
I've tried staring with all my might at the different options in the hopes I might identify something. I did turn off the features suggested above in the comment field, but have still been unable to solve it.
I don't understand why that guy suggested turning off DHT and Local Peer Discovery. It shouldn't matter...If you have the client bound to the VPN interface, then that should be that.
I think it could be a bug. You're right in how it works. Once you've set the interface, it will expect that even if you disable your VPN and blocks connection
If you disable your VPN, does the interface change in advance settings?